Troubleshooting

My permanent dongle is expired
When running Inspector, you may run into the following issue: License ID:         1A2B3C4D License Status:   Expired License Version:  3.0 License Typ...
Wed, 15 Aug, 2018 at 9:18 AM
My Spider modules cause a compilation error
Details When compiling any module that uses the Spider framework in 2018.3 onwards, you could see a compile error. This error is caused by the fact that as...
Tue, 5 Feb, 2019 at 2:12 PM
EM Probe Station driver does not work
Affected versions: Inspector 2018.x There was a problem with the driver distribution of the EM Probe Station in Inspector 2018.x, which causes the drive...
Wed, 22 May, 2019 at 8:30 AM
Using a LeCroy scope with Inspector
Measuring using a LeCroy with Inspector requires quite a bit of preparation, and there are many ways you can get stuck. Here you will find the most common p...
Mon, 22 Jul, 2019 at 11:07 AM
I don't know my LeCroy admin password
The new LeCroy scopes that have Windows 10 installed require an admin password to install programs or make modifications to the system.  The admin password...
Mon, 22 Jul, 2019 at 11:10 AM
BBI on smartcards
Problem BBI can interfere with, or even break, smart card measurement equipment such as the PowerTracer or the MP300/MP500. Description BBI (body bias...
Tue, 8 Oct, 2019 at 10:49 AM
I can't connect to Transceiver from Inspector
Since Inspector 2020.1, it's possible to set up the Transceiver from Inspector. However, there are a few requirements that need to be met before this wi...
Mon, 14 Dec, 2020 at 12:02 PM
Troubleshooting Piñata
Noise Floor Piñata (as most embedded targets out there) needs certain preparation before proceeding to an evaluation. We describe the process usually as fo...
Thu, 10 Feb, 2022 at 2:39 PM
Troubleshooting the EMMI camera
Recent versions of EMMI camera have been unstable while operating with FIPy. There is a workaround that makes the camera work quite stable and you can find ...
Fri, 7 Oct, 2022 at 3:52 PM